Builder line of credit vs construction loan: how each shows in the books
Per-house loans, revolving builder lines and working capital lines, and how to record each.
Short answer: A construction loan funds one house against an approved budget and is paid off when that house sells or refinances. A builder line of credit revolves: you draw, repay and draw again, often limited by a borrowing base across several homes. Both are liabilities, never income. Track each loan, and each house's share of a line, separately.
Three kinds of builder debt
Builders use the words loan and line loosely, but lenders and your books treat these differently. Most owner-led builders see one or more of these:
- Per-house construction loan. One loan, one house. The lender approves a budget, funds draws as an inspector confirms progress and is repaid from the sale or the buyer's permanent mortgage. See the construction loan draw process.
- Revolving builder line with a borrowing base. One facility that funds several houses. The OCC's Comptroller's Handbook describes these as revolving credit agreements where the amount available is set by a borrowing base: the type and value of the collateral and an advance rate for each type, such as land, developed lots, homes under construction and completed unsold homes. Advance rates are usually lower for riskier collateral, so a finished lot supports less borrowing than a completed home.
- Working capital line. A general line used to bridge timing gaps for overhead or deposits before a draw arrives. It is usually not tied to one house.
Government-backed versions exist too. The SBA's Builders CAPLine finances small contractors and home builders building or rehabilitating property for resale. Under SBA rules, up to 33 percent of proceeds may go to land, and the term cannot exceed 60 months plus the estimated time to complete construction. Whether any of these fits is a question for your lender.
How a per-house construction loan shows in the books
- One liability account per loan. Name it with the lender and the house address. Intuit's guidance is to use an Other Current Liabilities account with the Loan Payable detail type for a loan you will repay within the fiscal year, and a Long Term Liabilities account for one you will not. Most spec construction loans are short term, but confirm the classification with your CPA.
- Draws raise the loan, not income. When the lender wires a draw to you, record a deposit coded to the loan account. When the title company or lender pays trades directly, record the bills as paid from the loan account. Either way, the cost still goes to the house's cost codes.
- Interest. Interest may be paid monthly or charged to an interest reserve. See construction loan interest reserves. Whether interest during construction is capitalized into the house is a CPA question.
- Payoff at sale. The payoff comes off the settlement statement and should bring the loan account to zero. See recording a spec home sale in QuickBooks Online.
On a custom home where the client holds the construction loan, the loan is not yours. Draws are customer payments against the contract, not loan proceeds. See retainage and customer deposits.
Want your loans tracked by house and ready for your lender? Request a Relationship Assessment.
How a revolving builder line shows in the books
- One liability account per line. In QuickBooks Online, Intuit's setup for a line of credit is an Other Current Liabilities account with the Line of Credit detail type, plus an Interest Paid expense account. Name the account with the lender and the last digits of the line so it reconciles to the bank statement.
- Record each draw as a deposit to your operating account coded to the line, and each payment split between principal (to the line) and interest. Reconcile the line to the lender's statement every month.
- Track each house's share. The ledger only knows the total balance. Keep a schedule by house of what was drawn for it, so you know what each sale must repay and so interest can be allocated by house if your CPA wants it capitalized. Use the house's project in the memo or a class, and tie the schedule to the line balance at month end.
- Release prices. Construction loan agreements that cover several units usually require a pay down as each one sells, and the release price is often more than that unit's share of the loan, so the bank is paid off before the last homes sell. The OCC handbook calls this acceleration. Know each house's release price before closing, because it drives how much cash the sale actually frees up.
The borrowing base certificate comes from your books
Under a borrowing base line, the OCC notes that availability is based on frequent, usually monthly, reports the borrower prepares, called borrowing base certificates. The certificate lists collateral by category and value, and the lender checks it on site from time to time. Lenders also commonly limit the number of spec units and how long a completed unsold home can stay in the base.
That means your monthly books feed your borrowing power. To fill in a certificate without guessing, you need:
- Each house's cost to date, from job cost by house, and its status: lot, under construction, complete and unsold, or under contract.
- The date each house was completed, so aging limits are not missed.
- The line balance reconciled to the lender's statement.
- A clean month-end close done before the certificate is due. See our month-end close checklist.
Covenants are accounting numbers
The OCC lists covenants lenders may use on construction and development loans, including limits on spec and unsold units, limits on other debt, and minimum liquidity, net worth or debt to worth. Those are read straight from your balance sheet. If inventory, loan balances or retained earnings are wrong, you can look out of compliance when you are not, or the other way around. A clean P&L and balance sheet each month protect the line.
Which fits your company?
This is a conversation for your lender and CPA, not us. From the books side, per-house loans keep each house's financing simple to track and are common for builders with a few homes at a time. A revolving line can cut paperwork across many starts but asks more of your reporting every month. If you run more than one entity, keep each loan or line in the entity that owes it. See multi-entity job costing.
How we help
Our team sets up each loan and line correctly in QuickBooks Online, reconciles them to lender statements, keeps the schedule by house and prepares the numbers for borrowing base certificates in the monthly close. Our founder reviews every close. We quote a flat monthly price for each builder, starting at $1,500 a month, with typical engagements between $2,500 and $8,500 a month. Start with a $1,500 Margin Review for written findings. See construction bookkeeping, fractional controller, pricing or request a Relationship Assessment.
Sources
- OCC, Comptroller's Handbook: Commercial Real Estate Lending (PDF)
- OCC, Frequently Asked Questions: Residential Tract Development Lending (Bulletin 2005-32)
- eCFR, 13 CFR Part 120 Subpart C, Builders Loan Program
- SBA, Types of 7(a) loans (CAPLines)
- Intuit, Manage a line of credit in QuickBooks Online
- Intuit, Set up a loan in QuickBooks Online
Common questions
Is a construction loan draw income?
No. A draw on your own construction loan or line increases a liability. On a custom home where the client holds the loan, the draw is a customer payment against the contract.
How do I set up a line of credit in QuickBooks Online?
Create an Other Current Liabilities account with the Line of Credit detail type and an Interest Paid expense account. Record draws as deposits coded to the line and split payments between principal and interest.
What is a borrowing base?
A limit on a revolving line set by the type and value of your collateral and an advance rate for each type, such as lots, homes under construction and completed homes. You usually report it monthly on a borrowing base certificate.
What is a release price?
The amount a lender requires to release its lien on one unit when it sells. It is often more than that unit's share of the loan, so the loan is repaid before the last units sell.
Should each house have its own loan account?
For per-house construction loans, yes. For a revolving line, keep one account for the line and a schedule by house that ties to it.
Can you prepare our borrowing base numbers?
Yes. Our team keeps cost by house and loan balances reconciled in the monthly close, so the certificate numbers come straight from the books. Our founder reviews every close.
Related
- The construction loan draw process
- Construction loan interest reserves
- Recording a spec home sale in QuickBooks Online
- Spec home accounting
- 13-week cash forecast for builders
- Construction bookkeeping
- Glossary: Interest reserve
- Glossary: 13-week cash forecast
- Glossary: Construction loan
- Request a Relationship Assessment
- What a bank asks for at line of credit renewal
By John Mos, Founder. Updated . We do not give tax or legal advice. Please ask your CPA or attorney.
See where your margin goes, house by house.
Tell us about your homes and your books. If we are a fit, we start with a $1,500 Margin Review: written findings and a fixed quote in 10 business days, credited to your onboarding fee if you sign up.